この二つを見比べてみたんだけど 「対応しているメモリー構成」(Supported memory configurations)の表のところの注釈、 >Support for one 4 GB SO-DIMM installed in slot 1. Slot 0 must be left empty. がD2700DCにはあるけど、DN2800MTの方はそれどころか注釈が無い
New Fixes/Features: . Changed the default value of Swap Mode from Enable to Disable. . Implemented the PHED (Panel Header) and BDDC (Panel EDID) in OpRegion. . Fixed issue where down-arrow key of the keyboard does not work properly under DOS. . Fixed issue where the POST hotkey does not show properly if the logo is set to a 320x200 image. . Hid swap mode question if LVDS interface type is set to single channel.
>>816 もしかしてSATAを2台付ける予定? だったら駄目だね SATAを1台ならMB上にSATA power connectorが有るから大丈夫だけど SATA power connectorの分岐ケーブルなんて売ってたかな? スリムDVDとかだったら俺ならUSBの外付けにするけどな 外付けにすれば空間に余裕が出て温度管理も余裕が出るんじゃないか?
↑のp71に > 2.6.3 PCI Express* Add-in Card Considerations > The motherboard is designed to provide up to 10 W to the PCI Express x1 slot. > The total power consumption from add-in boards on this slot must not exceed this rating.
でも上のpdfのp28にはこう書いてある。 > NOTE > Board power supplied through the SATA power connector is rated at a maximum of: > ・1.0 A from 12 V rail > ・2.5 A from 5 V rail > ・0.5 A from 3.3 V rail